cad

I needed some place to put my 2019 Kia Niro 120v charger. There were several good designs floating arount but all of them were designed to be mounted to a wall. My garage had a 3" metal pole where I wanted the charger to be. I was able to borrow specs from a few other designs and combine them along with my own wants to build a pole mounted setup. It used several u-bolts to connect the bits together and hold them tight to the pole. [Read More]

This is a replica weapon from the game Fallout: New Vegas. The Plasma Defender prop was built in SketchUp and printed on a Makerbot Replicator 2012.

My wife is a long-time fan of Ender’s Game, so when the movie came out she decided to make a Dragon Army Flash Suit. Naturally, this meant she needed a gun to go with it, which is where I came in. I designed the gun in SketchUp and printed the original on a MakerBot Replicator Dualstrusion. I started out by tracing a side view picture from the movie of the gun. [Read More]

This a replica of the short staff Loki used to mind control Hawkeye and several others, and escape from the S.H.I.E.L.D. compound. This item is approximately 96 cm long (36 in). This version is redesigned to increase the ease of building and strength of the joints. It also uses an Arduino Pro Mini with an Addressable RGB strip to animate the crystal and give this item more power. Notice: This device will not grant you the ability to fire energy blasts or take over the minds of your enemies. [Read More]